Want to clone from receiver to receiver? Follow the instructions below.
All information will be transferred from your master receiver into your second (slave) receiver. |
|
- |
|
How to check the loader version |
|
 | Menu->Accessory->System Information |
|
|
|
Receiver (loader version 1.0.3)
to receiver (loader version 1.0.3) cloning. |
|
| Note: Old receiver.(loader version
older than 1.0.3) must update loader (version 1.0.3)
first. |
| Connect Receiver (master) & receiver (slave) -
(RS232-RS232,Pin 2-Pin 3,Pin 3-Pin 2,Pin 5-Pin 5). |
| Turn on the power of master receiver. |
| Wait for the receiver to boot up. |
| Turn on the power of slave receiver. |
| Wait until finished. |
|
|
|
Receiver (loader version 1.0.1)
to receiver (loader version 1.0.1) cloning. |
|
| Connect Receiver (master) & receiver (slave) -
(RS232-RS232,Pin 2-Pin 3,Pin 3-Pin 2,Pin 5-Pin 5). |
| Turn on the power of master receiver. |
| Wait about 10 sec. Turn on the power of slave receiver. |
| Wait until finished. |
|
|
|
How to download new loader from PC to receiver |
|
| Download and install SC-16 upgrade software. |
| Connect Receiver & PC. |
| Run SC-16 upgrade software. |
| Select the COM in COM option (normally COM1). |
| Select Download Loader item in upgrade option. |
| Open file, loader103.bin (Download Software file name).
|
| Press Start. |
| Turn on the power of receiver. |
| Wait until finished. |
|
|
|
Need the current software? |
|
|
The COM tool Software
you will need this to load any of the software below |
Traxis-16M |
|
The COM tool Instructions
read this carefully |
Traxis COM Tool |
New software (10/26/2004)
| This software is satellite name changes. This software serves no other
purpose. |
|
DBS2500-20041026-app |
Loader Software - latest loader software (installs into your
receiver) (instructions are included)
|
How to check the receiver loader
version |
|
| Menu->Accessory->System Information |
|
| Loader
V1.0.3 |
|
|
